Steel rail 49E1 (S49) manufactured according to European standard EN 13674-1 with a mass of 49,39 kg per meter. Specifications: Size: 49E1/S49 rail Length: 5m~25m or other lengths according to customer requirements Material: R200, R260, R260MN, R350HT Standard: EN 13674-4 Weight: 49.39kg/m Type of ... Read More
|
UIC 60kg steel rail has good comprehensive mechanical properties and is suitable for railway sections with complex forces, and is widely used along railway lines in various countries. The 60kg steel rail can be used for laying main railway lines, seamless railway lines, mines, shaft rails, crane ... Read More
|
Dimensions: Type of Rail Standard Dimensions mm Section S Mass m H B C D E cm² kg/m 49E1 (S49) EN 13674 - 1 149,00 125,00 67,00 51,50 14,00 62,92 49,39 Description: Rail 49E1 (S49) manufactured according to European standard EN 13674-1, mass 49,39 kg per meter. Drawings: Read More
|
60KG/M Rail Mechanical Properties: Standard length: 12.19 m & 13.72 m Weight: 60.6 kg/m Typical Mechanical Properties: 0.2% Proof Stress MPa : 420 Tensile Strength MPa : 880 % Elongation Gage Length = 5.65 √So 8 Surface hardness H.B : 260 Chemical Composition (%) Ladle Analysis: Carbon: 0.65 - 0.82 ... Read More
|
The company developed a wheel pressure estimation equipment and method. The wheel pressure estimation apparatus includes an inputter configured to receive a brake signal output from the electronic control braking apparatus and to receive a brake pedal signal detected from the detector and a pressure ... Read More
|
The company has developed a convenient disassembly unit for wheel molds, which includes an upper mold. A plurality of lower support blocks are fixed on the bottom edge of the upper mold, a lifting hydraulic cylinder is fixed on the top surface of the edge of the upper mold, a pull arm is fixed on ... Read More
|
The company has developed a wheel die split cone and its processing method, which is composed of a split cone body (1) and a split head (2). The split head (2) is set at the lowest end of the split cone body (1), and the split cone body (1) and the split head (2) are fastened by bolts + welding. The ... Read More
|
The company has developed a full water-cooled point cooling structure and method for the wheel mold bottom mold. It mainly comprises a bottom mold, the bottom mold is provided with a back cavity and a plurality of cooling holes for fixed-point cooling, the bottom mold is provided with a cover plate, ... Read More
|
The company has developed a wheel mold gate device, which belongs to the technical field of wheel processing. According to the technical scheme provided by the utility model, the wheel mold gate device comprises a gate cover plate and a gate cup under the gate cover plate; The outer ring of the gate ... Read More
|
The company developed a digital wheel mold, including top mold, bottom mold, side mold, bolt hole ejector rod, bolt hole ejector rod head plane, and two-dimensional code on the ejector rod head plane. Install the bolt hole ejector rod with two-dimensional code to the wheel mold ejector. The ... Read More
|